Table of Contents
Advertisement
To remove the system-board tray cover, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the system-board tray and all attached devices (see "Turning off the
3. If the system-board tray is installed in a chassis, remove it (see "Removing a
4. Carefully set the system-board tray on a flat, static-protective surface, with the
5. Pull the cover release on each side of the system-board tray outward; then, lift
6. Lift the cover off the system-board tray and store it for future use.
Removing an expansion enclosure
To remove an expansion enclosure, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the system-board tray and all attached devices (see "Turning off the
3. If the system-board tray is installed in a chassis, remove it (see "Removing a
4. Carefully set the system-board tray on a flat, static-protective surface.
5. If you are removing the enclosure, note the cable routing and connection
6. Pull the expansion-unit release on each side of the system-board tray outward;
on page 23.
system-board tray" on page 21).
system-board tray from a 2U chassis" on page 25 or "Removing a system-board
tray from a 3U chassis" on page 27).
cover side up.
the cover open.
Note: If two system-board trays are installed in a 2U chassis, covers must be
installed on both of them.
Expansion
enclosure
on page 23.
system-board tray" on page 21).
system-board tray from a 2U chassis" on page 25.
locations; then, disconnect the cables that connect the expansion enclosure to
the system-board tray.
then, rotate the expansion enclosure open.
Release
latch
System-board
tray
Chapter 3. Installing optional devices
29
Advertisement
Table of Contents
