Reinstalling a system-board tray in a 2U chassis
To reinstall a system-board tray in a 2U chassis, complete the following steps:
1. If an expansion enclosure is installed on the system-board tray, make sure that
2. Slide the system-board tray into the chassis until it stops and the release
3. Reconnect the cables on the front of the system-board tray.
4. Turn on the system-board tray (see "Turning on the system-board tray" on page
5. Make sure that the power-on LED on the system-board tray operator panel is lit
If you have changed the configuration of the system-board tray, you might have to
update the server configuration through the Setup utility (see "Updating the server
configuration" on page 51).
the blue air damper actuator is parallel to the system-board tray before you slide
the assembly into the chassis.
handles click into place.
21).
continuously, indicating that the system-board tray is receiving power and is
turned on.
Chapter 3. Installing optional devices
47