Changes To Table 1 - Analog Devices EVAL-ADM2482EEB3Z User Manual

UG-210
Table 1. Board Configurations and Jumper Settings
Configuration
Full Duplex Configuration
Half-Duplex Configuration (A Connected to Y, B Connected to Z)
No Biasing Resistors
Bus Biasing Resistors on A/B only
Bus Biasing Resistors on Y/Z only
Bus Biasing Resistors on A/B and Y/Z (Full Duplex)
No Termination Resistors
Termination Resistor on A/B only
Termination Resistor on Y/Z only
Termination Resistors on A/B and Y/Z (Full Duplex)
Powering the Bus Side Using the Regulator on the Board
Powering the Bus Side Using an External Power Supply
Using the Transformer on the Board
Using the SMA Connector for RxD
Using the Screw Terminal for RxD
Using the SMA Connector for TxD
Using the Screw Terminal for TxD
RE High
RE Low
Using the Screw Terminal for RE
DE High
DE Low
Using the Screw Terminal for DE
Tie RE and DE Together (Note Only One Jumper Can Be Inserted, Either
LK4 or LK6)
Jumpers Fitted
LK15, LK16
LK11, LK13
LK7, LK9
LK7, LK9, LK11, LK13
LK12
LK10
LK10, LK12
LK1 (Position B)
LK1 (Position A)
LK2 (Position A)
LK3 (Position A)
LK8 (Position A)
LK8 (Position B)
LK5 (Position B)
LK5 (Position A)
LK4 (Position A)
LK4 (Position B)
LK4 (Position C)
LK6 (Position A)
LK6 (Position B)
LK6 (Position C)
LK14 and (LK4 or LK6)
Rev. A | Page 4 of 12
Evaluation Board User Guide
Jumpers Open
LK 15, LK16
LK7, LK9, LK11, LK13
LK7, LK9
LK11, LK13
LK 15, LK16
LK10, LK12
LK10
LK12
LK 15, LK16
LK1 (Position A)
LK1 (Position B)
LK2 (Position C)
LK3 (Position C)
LK8 (Position B)
LK8 (Position A)
LK5 (Position A)
LK5 (Position B)
LK4 or LK6