Parent Unit Power Supply - Motorola MBP662CONNECT User Manual

1. Insert the wire tabs of the rechargeable battery pack into the contact slots
as shown above and fit the battery pack into the compartment.
2. Place the battery cover over the compartment and gently tighten the
screw in a clockwise direction using a small cross-head or flat-head
screwdriver.
2.3

Parent Unit Power Supply

IMPORTANT
It is recommended that the rechargeable battery pack be installed and
charged fully before use. This will allow the Unit to operate on battery in the
event of a power failure, or when moving it to a different room.
1. Connect the small plug of the power adapter to the Parent Unit and the
other end to a mains power socket. Only use the enclosed power adapter
(5V DC/600mA).
2. Press and hold the POWER ON/OFF button
the Parent Unit.
3. Once the Baby and Parent Units are switched on, the display on the Parent
Unit will show the video captured by the Baby Unit.
Getting Started
Small cross-head or flat-head
screwdriver.
for 1 second to switch on
11