Registration (Pairing) - Motorola MBP662CONNECT User Manual

4. If there is no connection or the Units are out of range with each other, the
video display will go off, the symbol
the Unit will beep every 9 seconds. Move the Parent Unit closer to the Baby
Unit to re-establish the link.
5. To switch off the Parent Unit, press and hold the POWER ON/OFF button
until the progress bar scrolls across fully.
NOTE
The battery icon
seconds to indicate that battery is low and needs to be recharged. The battery
pack will take approximately 16 hours to charge.
When charging
1. If the Parent Unit is switched OFF when the power adapter is plugged in,
an adapter icon will appear on-screen, followed by a large battery icon with
internal segments cycling for 60 seconds, before the display goes blank.
Note that the Parent Unit will continue to charge. The power indicator LED
on the top left corner will light up in blue to indicate that the adapter is
plugged in.
2. If the Parent Unit is switched ON when the adapter is plugged in, the
battery icon on the top right corner of the screen will show that the battery
is charging (with internal segments cycling). The segments stop cycling
when the battery is fully charged. The power indicator LED on the top left
corner will light up in blue to indicate that the adapter is plugged in.
2.4

Registration (Pairing)

The Baby Unit (Camera) is pre-registered to your Parent Unit. You do not need
to register it again unless the Baby Unit loses its link with the Parent Unit.
To re-register your Baby Unit, or register a new Baby Unit, follow the procedure
below:
1. Press the
MENU
+
2. Press the UP button or
/ /
<
3. Press the LEFT button or
button to confirm.
OK
12
will turn Red, flash and beep approximately every 5
button and the menu bar will pop up.
-
DOWN button until
/ menu will pop up.
>
RIGHT button to select
will flash on the LCD display, and
is highlighted. The
, and press the
Getting Started