Table of Contents
Advertisement
5.3.5
5.3.5
5.3.5
Primary/Secondary/Third IDE Master/Slave
Primary/Secondary/Third IDE Master/Slave
Primary/Secondary/Third IDE Master/Slave
5.3.5
5.3.5
Primary/Secondary/Third IDE Master/Slave
Primary/Secondary/Third IDE Master/Slave
The BIOS automatically detects the connected IDE devices. There is a separate
sub-menu for each IDE device. Select a device item, then press <Enter> to
display the IDE device information.
Main
Primary IDE Master
Device
: Hard Disk
Vendor
: ST320413A
Size
: 20.0GB
LBA Mode
: Supported
Block Mode
: 16 Sectors
PIO Mode
: Supported
Async DMA
: MultiWord DMA-2
Ultra DMA
: Ultra DMA-5
SMART Monitoring: Supported
Type
LBA/Large Mode
Block(Multi-sector Transfer) [Auto]
PIO Mode
DMA Mode
SMART Monitoring
32Bit Data Transfer
v02.58 (C)Copyright 1985-2004, American Megatrends, Inc.
The BIOS automatically detects the values opposite the dimmed items (Device,
Vendor, Size, LBA Mode, Block Mode, PIO Mode, Async DMA, Ultra DMA, and
SMART monitoring). These values are not user-configurable. These items show
N/A if no IDE device is installed in the system.
Type [Auto]
Type [Auto]
Type [Auto]
Type [Auto]
Type [Auto]
Selects the type of IDE drive. Setting to [Auto] allows automatic selection of
the appropriate IDE device type. Select [CDROM] if you are specifically
configuring a CD-ROM drive. Select [ARMD] (ATAPI Removable Media Device)
if your device is either a ZIP, LS-120, or MO drive. Configuration options: [Not
Installed] [Auto] [CDROM] [ARMD]
LBA/Large Mode [Auto]
LBA/Large Mode [Auto]
LBA/Large Mode [Auto]
LBA/Large Mode [Auto]
LBA/Large Mode [Auto]
Enables or disables the LBA mode. Setting to [Auto] enables the LBA mode if
the device supports this mode, and if the device was not previously formatted
with LBA mode disabled. Configuration options: [Disabled] [Auto]
Block (Multi-sector Transfer) [Auto]
Block (Multi-sector Transfer) [Auto]
Block (Multi-sector Transfer) [Auto]
Block (Multi-sector Transfer) [Auto]
Block (Multi-sector Transfer) [Auto]
Enables or disables data multi-sectors transfers. When set to [Auto], the
data transfer from and to the device occurs multiple sectors at a time if the
device supports multi-sector transfer feature. When set to [Disabled], the
data transfer from and to the device occurs one sector at a time. Configuration
options: [Disabled] [Auto]
A S U S R S 1 2 0 - E 3 / P A 4
A S U S R S 1 2 0 - E 3 / P A 4
A S U S R S 1 2 0 - E 3 / P A 4
A S U S R S 1 2 0 - E 3 / P A 4
A S U S R S 1 2 0 - E 3 / P A 4
BIOS SETUP UTILITY
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Disabled]
Select the type of
device connected to
the system.
Select Screen
Select Item
+-
Change Option
F1
General Help
F10 Save and Exit
ESC Exit
5 - 1 7
5 - 1 7
5 - 1 7
5 - 1 7
5 - 1 7
Advertisement
Table of Contents
