Table of Contents
Advertisement
4.3
Connectors
1 . 1 .
1 .
F l o p p y d i s k d r i v e c o n n e c t o r ( 3 4 - 1 p i n F L O P P Y 1 )
F l o p p y d i s k d r i v e c o n n e c t o r ( 3 4 - 1 p i n F L O P P Y 1 )
1 .
1 .
F l o p p y d i s k d r i v e c o n n e c t o r ( 3 4 - 1 p i n F L O P P Y 1 )
F l o p p y d i s k d r i v e c o n n e c t o r ( 3 4 - 1 p i n F L O P P Y 1 )
F l o p p y d i s k d r i v e c o n n e c t o r ( 3 4 - 1 p i n F L O P P Y 1 )
This connector is for the provided floppy disk drive (FDD) signal cable.
Insert one end of the cable to this connector, then connect the other
end to the signal connector at the back of the floppy disk drive.
Pin 5 on the connector is removed to prevent incorrect cable connection
when using a FDD cable with a covered Pin 5.
®
P5MT-R
P5MT-R Floppy disk drive connector
2 . 2 .
2 .
2 .
2 .
I D E c o n n e c t o r ( 4 0 - 1 p i n P R I _ I D E 1 )
I D E c o n n e c t o r ( 4 0 - 1 p i n P R I _ I D E 1 )
I D E c o n n e c t o r ( 4 0 - 1 p i n P R I _ I D E 1 )
I D E c o n n e c t o r ( 4 0 - 1 p i n P R I _ I D E 1 )
I D E c o n n e c t o r ( 4 0 - 1 p i n P R I _ I D E 1 )
This connector is for an Ultra ATA 100/66/33 signal cable. By default,
this connector supports the optical disk drive. You must configure the
optical drive as master/slave device by setting its jumper accordingly.
Refer to the optical disk drive documentation for the jumper settings.
Pin 20 on the IDE connectors are removed to match the covered hole on
the Ultra ATA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
®
P5MT-R
P5MT-R IDE connector
A S U S R S 1 2 0 - E 3 / P A 4
A S U S R S 1 2 0 - E 3 / P A 4
A S U S R S 1 2 0 - E 3 / P A 4
A S U S R S 1 2 0 - E 3 / P A 4
A S U S R S 1 2 0 - E 3 / P A 4
FLOPPY1
PIN 1
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
PRI_IDE1
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PIN 1
4 - 9
4 - 9
4 - 9
4 - 9
4 - 9
Advertisement
Table of Contents
