Honeywell LXL-1000 User Manual page 44

Fire Alarm System
Manually
Initiating
a Fire Alarm
Using the
Panic Key(s)
Assigned for
Emergency
– 44 –
www.PDF-Zoo.com
THIS SECTION APPLIES ONLY TO RESIDENTIAL SYSTEMS
1. Should you become aware of a fire emergency before your smoke or heat
detectors sense the problem, go to your nearest keypad and manually
initiate an alarm by pressing the panic key assigned for FIRE emergency for
2 seconds (see below). If a key pair has been assigned for fire, press both
keys at the same time. See the Using the Panic Keys section below for
further details.
2. Evacuate all occupants from the premises.
3. If flames and/or smoke are present, leave the premises and notify your local
Fire Department immediately.
4. If no flames or smoke are apparent, investigate the cause of the alarm. The
zone number(s) of the zone(s) in an alarm condition will be displayed at the
keypad.
A key or key pair may have been assigned for manually initiating a
FIRE alarm. See the Panic Keys section for key assignments.
For convenience, indicate the key or key pair assigned for fire below.
FIRE
In divi dua l Key s
A B
O R
Key Pai r s
1
OFF
Q
READY
3
STAY
DISPLAYS FOLLOWING MANUAL INITIATION OF A FIRE ALARM
F I R E 9 5
ALPHA DISPLAY KEYPAD
(cont'd)
C
Press the individual key assigned for fire for 2 seconds.
Q
and READY
Press both keys of the key pair
assigned for fire at the same time.
#
and
#
and
AC
95 95 95 95
ALARM
FIRE
FIXED-WORD KEYPAD