In The Event Of Telephone Operational Problems - Honeywell LXL-1000 User Manual

Other Trouble
Total Power Failure
In the event of telephone operational problems, disconnect the control from the phone line by
removing the plug from the phone wall jack. We recommend that your installer demonstrate this
disconnection on installation of the system. Do not attempt to disconnect the phone connection
inside the control. Doing so will result in the loss of your phone lines. If the regular phones work
correctly after the control has been disconnected from the phone wall jack, the control has a
problem and you should immediately call for service. If upon disconnection of the control, there is
still a problem on the phone line, notify the Telephone Company that they have a problem and
request prompt phone repair service. The user may not under any circumstances attempt any
service or repairs to the security system. Repairs must be made only by authorized service (see
the LIMITED WARRANTY statement for information on how to obtain service).
www.PDF-Zoo.com
AC LOSS
Displays
(or NO AC)
(Continued)
Busy-Standby
(or dI)
Long Rng Trbl
(or bF)
TELCO FAULT
(or CHECK 94)
If there is no keypad display at all, and the READY indicator is not
lit, operating power (from AC and back-up battery) for the system
has been interrupted and the system is inoperative. CALL FOR
SERVICE.

In The Event Of Telephone Operational Problems

Trouble Conditions
The system is operating on battery power
only due to an AC power failure.
If only some lights are out on the
premises, check circuit breakers and
fuses and reset or replace as necessary.
If AC power cannot be restored and a
"low system battery" message appears
(see previous page), CALL FOR
SERVICE.
If this message remains displayed for
more than 1 minute, system is disabled.
CALL FOR SERVICE.
If part of your system, back-up Long
Range Radio communication has failed.
CALL FOR SERVICE.
The telephone line has a problem.
CALL FOR SERVICE.
(cont'd)
– 41 –