Disarming And Silencing Alarms - Honeywell LXL-1000 User Manual

IMPORTANT: If you return and the main burglary sounder is on, DO NOT
ENTER, but CONTACT THE POLICE from a nearby safe location.
If you return after an alarm has occurred and the main sounder has shut itself off,
the keypad will beep rapidly upon your entering, indicating that an alarm
has occurred during your absence.
LEAVE AT ONCE, and CONTACT THE POLICE from a nearby safe location.
To Disarm the system simply enter your 4-digit
security code:
Clear a Memory of Alarm
www.PDF-Zoo.com

Disarming and Silencing Alarms

(4-digit Security Code)
The keypad will emit a single tone to confirm that
the system is disarmed and the RED LED indicator
will go out.
If the system was in ALARM, note the zone in alarm
on the keypad display and correct the problem (close
door, window, etc.). After correcting the problem,
clear the keypad's Memory of Alarm display as
described below.
Enter your 4-digit security code and press the OFF key (after disarming) to
clear Memory of Alarm from the keypad.
To Temporarily Silence an Alarm
Simply press the OFF key to silence the alarm. The system will not be disarmed
(as indicated by the RED LED indicator on the keypad) until you enter your 4-
digit security code as described above.
Alpha Display:
DISARMED
✱✱✱✱ ✱✱✱✱
READY TO ARM
Fixed-Word Display: READY
– 21 –