Table of Contents
Advertisement
Owners manual
6.4 Installing Rear Wheels - Quick-Release Axle
Make sure the positioning device E is inserted in block F;
1.
Secure it firmly in place with the lock washer D and nut C;
2.
Insert axle A in the positioning device E with the wheel hub B.
3.
6.5 Adjusting Quick Release Axle
Tighten or loosen nut C with a 3/4" wrench and a 7/16" wrench.
Make sure the detent pin and detent balls of the quick release axle are fully release
before operating the wheelchair. The detent balls MUST be protruding past the
inside of the rear wheel axle bushing for a positive lock. Lubricate if necessary.
Keep quick-release axles free of dirt and lint to ensure positive locking and proper
operation.
Figure 14 : Rear Wheel Installation
Figure 15: Adjusting Quick Release Axle
17
ENGLISH
Revision 5
January 2016
Advertisement
Table of Contents
