Table of Contents
Advertisement
2.6
Others
Setting the Parallelled SLT to Ring (Parallelled Telephone Connection)
A proprietary telephone (PT) can be connected in parallel with a standard single line
telephone (SLT). This feature allows you to enable or disable SLT ringing. When a parallel
connection is made, either telephone can be used.
T
o enable / disable SLT ringing
SLT and PT
6
Off-hook
!
• Default is "Parallel Off (SLT ringing disabled)."
!
• The PT can be used to perform normal operations whether or not an SLT is enabled.
• When receiving a call:
— If SLT ringing is enabled, then both the PT and the SLT ring except when the PT is in
the "Handsfree Answerback" mode or Voice-Calling mode.
— If SLT ringing is disabled, then the PT rings but the SLT does not. However the SLT
can answer the call.
• When the SLT is in use, the display and the indicators of the PT will show in the same
way as if the PT is in use.
• If you go off-hook while your parallelled telephone is in use, the call will switch over to
your telephone, and vice versa. (PT only)
• The "XDP*" feature is available. Refer to System Management.
• With the KX-T7235, KX-T7433 and KX-T7436, you can execute this feature with the
display operation.
• Display Operation (Section 2.7)
System Feature List
• System Management (Section 3.1)
EXtra Device Port (XDP)
• Connecting the Telephones in Parallel (Section 4.10)
* A XDP (eXtra Device Port) expands the number of telephones available in the system by allowing an
extension port to contain two telephones.
1
to enable
9
0
to disable
Dial 69.
Dial 1 or 0.
Confirmation
On-hook
tone
2-67
Operations
Advertisement
Table of Contents
