Power Supply Cage Assembly - HP ProLiant DL385 G7 Maintenance And Service Manual

Remove the three T-10 Torx screws, and then detach the front bezel.
8.
To replace the component, reverse the removal procedure.

Power supply cage assembly

To remove the component:
Power down the server (on page 26).
1.
Access the product rear panel (on page 28).
2.
Remove all power supplies
3.
Remove the server from the rack (on page 27).
4.
Remove the access panel
5.
Remove the PCI riser cage
6.
Remove the air baffle
7.
Remove the power supply backplane
8.
Loosen the system board thumbscrews, and then slide the system board assembly forward.
9.
("Hot-plug power supply" on page 31).
("Access panel" on page 33).
("PCI riser cage" on page 43).
("Air baffle" on page 53).
("Power supply backplane" on page 37).
Removal and replacement procedures 69