Hot-Plug Power Supply - HP ProLiant DL385 G7 Maintenance And Service Manual

To replace the component, reverse the removal procedure.

Hot-plug power supply

WARNING:
power supply blank to cool before touching it.
CAUTION:
all bays are populated with either a component or a blank.
To remove the component:
Determine how many hot-plug power supplies are installed:
1.
If only one hot-plug power supply is installed, power down and remove the power cord from the
o
server
If more than one hot-plug power supply is installed, continue with the next step.
o
Access the product rear panel (on page 28).
2.
Disconnect the power cord from the power supply.
3.
To reduce the risk of personal injury from hot surfaces, allow the power supply or
To prevent improper cooling and thermal damage, do not operate the server unless
("Power down the server" on page 26).
Removal and replacement procedures 31