Table of Contents
Advertisement
Removing head restraints
Seat position for removal of head restraints
from outboard second-row seats
1 Head restraint
2 Release button
To remove head restraint 1, pull head
restraint 1 to its uppermost position.
Press release button 2 and pull out
head restraint 1.
i
The head restraint of the second-row middle
seat* and the third-row seat head restraints are
removed in the same manner.
Installing head restraints
Insert head restraint 1 into openings
on the seat backrest.
i
On the outboard second-row seats, the
guide bar with the detent must be on the left.
Push head restraint 1 down until it
audibly engages.
Push release button 2 and adjust
head restraint 1 to the desired
position ( page 135).
i
The head restraint of the second-row middle
seat* and the third-row seat head restraints are
installed in the same manner.
Controls in detail
Armrests
6-seat vehicles
The second-row seat armrests can be
folded up, when loading for example, and
adjusted.
Folding up:
Move the armrest into a vertical
position until it engages.
Adjusting:
With the armrest folded up, disengage
the armrest by pushing it towards the
rear slightly.
Fold the armrest down to the lowest
and then to the desired position until it
engages.
To readjust the armrest to a higher
position, move armrest up to the
desired position until it engages.
i
To readjust the armrest to a lower position,
you must first fold up the armrest again and re-
peat the steps above.
Seats
137
Advertisement
Table of Contents
