Instructions To Repair The Gel Coat; Mixing Ratio; Application; Storage - Jeanneau MERRY FISHER 585 Owner's Manual

INSTRUCTIONS TO REPAIR THE GEL COAT

MIXING RATIO

Our products contain an accelerator, you just have to add the catalyst (a colourless
liquid). The usual ratio is 2 %
The gel setting time (working time) is about 1/2 h, curing takes about 10 h

APPLICATION

- To fill up a blister hole or a scratch, sand and clean the area with acetone.
- Prepare the necessary amount of gel coat, preferably on a glass plate.
- Apply the product with a spatula or a point and the layer shall be thick enough to make
possible a further sanding.
- In order to blend minor touching up on smooth surfaces, stick sellotape (or even better,
a mylar tape) on the freshly applied gel coat.
- Remove sellotape after curing.
- To get a highly shiny finish, sand with extra fine abrasive and water then polish.
Please respect the following conditions to repair successfully:
- Dry weather.
- Temperature between 15° C and 25° C.
- Keep it out of the reach of children.
- Avoid contact with skin and mucous membranes.
- In case of contact wash with soapy water and rinse thoroughly.

STORAGE

To keep them properly, store the gel coat components in a cool dry and dark place.
Keep the components 6 months maximum.
Polyester products are flammable ; take the usual precautions.
CLEANING YOUR TOOLS
Clean all your tools with acetone.
WARNING
DANGER
The catalyst is a dangerous product:
21/58
3