Con Trols And Con Nec Tions - Rear Panel - Telex RadioCom BTR-700 Operating Instructions Manual

Con trols and Con nec tions - Rear Panel

1
RECEIVE
TRANSMIT
POWER
I/C
NORM
HIGH TELEX COMMUNICATIONS INC.
ON OFF RTS
TELEX CLEARCOM
3 4
2
1. Re ceive An tenna - Fe male "TNC" Con nec tor. Color band
on an tenna must match color dot on base sta tion.
2. Trans mit Power Switch – HIGH = Trans mit ter at full
power. NORMAL = Trans mit ter 10dB be low full power.
3. Trans mit ON/OFF Switch – Turns the trans mit ter on or off.
4. I/C Se lect Switch – Set to the ap pro pri ate 2-wire in ter com
type be ing in ter faced to the unit. Set to ei ther Telex, RTS
or Clear-Com®.
BTR-700
FCC ID: B5DM516
CANADA 1321231218A
MADE IN USA
INTERCOM
AUXILIARY AUDIO
2 WIRE
PUSH PUSH
L
O
4 WIRE
O
P
T
H
R
U
INPUT
5 6
Fig ure 3
BTR-700 - Rear Panel
5. In ter com – In ter face to wired in ter com sys tem .
2-Wire – Male and Fe male 3 pin XLR con nec tors
wired in par al lel. The con nec tors are switched to the
ap pro pri ate in ter com con fig u ra tion via the I/C Se lect
Switch.
Warn ing! Ex ces sive cur rent through the
loop thru ports will dam age the in ter com!
Do not ex ceed 200 mA cur rent in the 2
wire loop thru curcuits.
4-Wire – An RJ-11 type jack com pat i ble with "Ma -
trix" type in ter com sys tems.
6. Aux il iary In put/Out put – One 3 pin fe male XLR in put
con nec tor and one 3 pin male XLR out put con nec tor.
7. Power – IEC re cep ta cle. Ac cepts 100 – 240VAC, 50 – 60 Hz
8. Trans mit An tenna - Fe male "TNC" Con nec tor. Color
band on an tenna must match color dot on base sta tion.
2-2
100-240 VAC 50-60 Hz
POWER
OUTPUT
8
TRANSMIT
7