Front Panel Con Trol And Con Nec Tions; Rear Panel Con Trols And Con Nec Tions - Telex RadioCom FM-1 Operating Instructions Manual

Front Panel Con trols and Con nec tions
1. Power Switch.
2. <MENU> and <SET> but tons – Used to se lect menus
and set op tions on the LCD.
3. Backlit Graphics LCD (Liq uid Crys tal Dis play).
4. <UP> and <SET> but tons – Used to se lect op tions on
the LCD.
5. Con trast Ad just – Ad justs the LCD's con trast.
6. Snap Shot But ton – Press and hold for 2 sec onds and
the user will be asked to check if a DataFlash® card is
in the "card reader" slot. Press again and a "snap shot"
of the BTR-1(s) will be taken. This will re cord fre -
quen cies and other im por tant pa ram e ters of the BTR-1
sys tem.
7. Card Reader Slot – Slot where the 2 MB DataFlash
card is in serted.
MENU
SET
1
UP
SNAP SHOT
DOWN
3 4 5 6
2
Front View of FM-1
CAN BUS
OUT TERMINATION
1 2
Rear View of FM-1
FM-1 Fre quency Man ager

Rear Panel Con trols and Con nec tions

1. CAN Bus Out – This RJ-45 jack is where the CAN
bus com mu ni ca tion goes out to the first BTR-1 base
sta tion.
2. CAN Bus Ter mi na tion - This RJ-45 jack is where the
CAN bus com mu ni ca tion ter mi nates from the last
BTR-1 base sta tion.
3. Power – IEC re cep ta cle. Ac cepts 100 – 240 VAC, 50 –
60 Hz.
RadioCom FM-1
Fig ure 4-1
RadioCom TM
FM-1
SYSTEMS MANAGER
P/N: 879830
S.N.: 0001
Telex Communications, Inc. Telex Communications, Inc.
8601 East Cornhusker Highway, Lincoln, NE 68507
Made in U.S.A. Made in U.S.A. 803995
Fig ure 4-2
4-1
Sec tion
TM
RE
Telex
R
7
100-240 VAC 50-60 Hz
POWER
3
4