Con Trols And Con Nec Tions - Rear Panel - Telex RadioCom BTR-700 Operating Instructions Manual

Con trols and Con nec tions - Rear Panel

1
RECEIVE
FCC ID: B5DM516
CANADA 1321231218A
TRANSMIT
POWER
I/C
HIGH NORM TELEX COMMUNICATIONS INC.
RTS
ON OFF
TELEX CLEARCOM
2 3 4
1. Re ceive An tenna - Fe male "TNC" Con nec tor. Color band
on an tenna must match color dot on base sta tion.
2. Trans mit Power Switch – HIGH = Trans mit ter at full
power. NORMAL = Trans mit ter 10dB be low full power.
3. Trans mit ON/OFF Switch – Turns the trans mit ter on or off.
4. I/C Se lect Switch – Set to the ap pro pri ate 2-wire in ter com
type be ing in ter faced to the unit. Set to ei ther Telex, RTS
or Clear-Com®.
BTR-700
2 WIRE
MADE IN USA
BTR-700 - Rear Panel
INTERCOM AUXILIARY AUDIO
PUSH PUSH
L
O
O 4 WIRE
P
T
H
R
U
INPUT OUTPUT
5 6
Fig ure 3
5. In ter com – In ter face to wired in ter com sys tem .
2-Wire – Male and Fe male 3 pin XLR con nec tors
wired in par al lel. The con nec tors are switched to the
ap pro pri ate in ter com con fig u ra tion via the I/C Se lect
Switch.
4-Wire – An RJ-11 type jack com pat i ble with "Ma -
trix" type in ter com sys tems.
6. Aux il iary In put/Out put – One 3 pin fe male XLR in put
con nec tor and one 3 pin male XLR out put con nec tor.
7. Power – IEC re cep ta cle. Ac cepts 100 – 240VAC, 50 – 60 Hz
8. Trans mit An tenna - Fe male "TNC" Con nec tor. Color
band on an tenna must match color dot on base sta tion.
2-2
8
100-240 VAC 50-60 Hz
TRANSMIT
POWER
7