Controls And Connections - Rear Panel - Telex RadioCom BTR-700 Operating Instructions Manual

Controls and Connections - Rear Panel

1
RECEIVE
CANADA 1321231218A
TRANSMIT
POWER TELEX COMMUNICATIONS INC.
I/C
NORM
HIGH
ON OFF RTS
TELEX CLEARCOM
3 4
2
1. Receive Antenna - Female "TNC" Connector. Color band
on antenna must match color dot on base station.
2. Transmit Power Switch – HIGH = Transmitter at full
power. NORMAL = Transmitter 10dB below full power.
3. Transmit ON/OFF Switch – Turns the transmitter on or off.
4. I/C Select Switch – Set to the appropriate 2-wire intercom
type being interfaced to the unit. Set to either Telex, RTS
or ClearCom®.
BTR-700
FCC ID: B5DM516
MADE IN USA
INTERCOM
AUXILLARY AUDIO
2 WIRE
PUSH PUSH
L
O
4 WIRE
O
P
T
H
R
U
INPUT
5 6
Figure 3
BTR-700 - Rear Panel
5. Intercom – Interface to wired intercom system .
2-Wire – Male and Female 3 pin XLR connectors
wired in parallel. The connectors are switched to the
appropriate intercom configuration via the I/C Select
Switch.
4-Wire – An RJ-11 type jack compatible with "Ma-
trix" type intercom systems.
6. Auxiliary Input/Output – One 3 pin female XLR input
connector and one 3 pin male XLR output connector.
7. Power – IEC receptacle. Accepts 100 – 240VAC, 50 – 60 Hz
8. Transmit Antenna - Female "TNC" Connector. Color
band on antenna must match color dot on base station.
2-2
100-240 VAC 50-60 Hz
OUTPUT POWER
8
TRANSMIT
7