Beltpack Set-Up; Bat Tery In Stal La Tion - Telex RadioCom BTR-700 Operating Instructions Manual

Beltpack Set-up

Bat tery In stal la tion

En sure that the On/Off vol ume con trol knob is turned off.
Press down and hold down the bat tery re lease latch, slide the
bat tery pack about 1/8 inch back, to ward the latch, un til it
stops. Then lift bat tery pack out. Re place bat ter ies as fol lows:
1. Open the bat tery pack by in sert ing
fin ger nail and lift ing.
2. Pull bat tery strap to re move low
or dead bat ter ies.
3. Load new bat ter ies fol low ing the
4. Start load ing at the end of the case where
the strap is at tached to the case.
5. Be sure strap goes un der bat ter ies.
6. Tuck end of strap un der door
when plac ing the bat tery cover
back on the case.
Fig ure 18
Bat tery In stal la tion
po lar ity as shown in bat tery case.
Do not place an al ka line TR bat tery
pack in any bat tery charger. Se vere
charger and bat tery pack dam age
may re sult.
4-8
WARNING