Pre-Walk-Thru Check List - Telex RadioCom BTR-700 Operating Instructions Manual

Fol low ing the in struc tions fully to this point you have suc cess - -
fully com pleted the fol low ing check list:
Lo cated the base sta tion prop erly.
Con nected power to base sta tion.
Con nected the 1/2-wave an ten nas to the base sta tion.
Checked fre quency range of the an tennas with the fre -
quency of the base sta tion by cor rectly match ing color
codes.
Con nected 1/4-wave an tenna to the beltpack. Checked
fre quency range of the an tennas with the fre quency of
the beltpack by cor rectly match ing color codes.
Base station trans mit power switches in the cor rect po -
si tions.
Trans mit mode switch on beltpack set correctly
Set wired in ter com type cor rectly.

Pre-Walk-Thru Check list

Con nected head sets to base sta tions (if needed) and all
beltpacks.
Con nected the base sta tion to any aux il iary au dio, in -
ter com or ex ter nal P.A. sys tem.
In stalled bat ter ies in the beltpack.
If you missed any of the above in struc tions, go back
and com plete that in struc tion be fore go ing on.
5-1
S
ection
5