An Tenna Con Nec Tion; Trans Mit Mode; Head Set Con Nec Tion - Telex RadioCom BTR-700 Operating Instructions Manual

An tenna Con nec tion

The beltpack co mes with two de tach able, screw type, ¼ wave
an ten nas. To at tach the two an ten nas, screw into the re cep ta - -
cles at the bot tom of the beltpack. The color dot on the screw
end of the an tenna must match the color dot on an tenna re cep - -
ta cle. The lon gest an tenna is the re ceiver an tenna. It screws
into the left re cep ta cle if the beltpack is lay ing flat with the
bat tery com part ment face up and the an tenna re cep ta cles fac - -
ing you. The other an tenna is the trans mit an tenna. New an - -
tennas can be or dered if de sired, see the "Ac ces sories"
sec tion.

Trans mit mode

The rear panel lo cated trans mit switch has the fol low ing two
modes:
Push-to-Talk (PT TALK) – Rec om mended po si tion –
The trans mit ter is al ways on. No au dio is sent un less the
talk switch is pressed.
Push-to-Transmit (PT TX) – The trans mit ter and au dio
paths are off ex cept when the talk switch is pressed.
MICROPHONE
GAIN CONTROL
TRANSMIT
SWITCH
HEADSET
CONNECTION
RECEIVE
ANTENNA
TRANSMIT
ANTENNA
Fig ure 19
TR-700 Rear Panel

Head set Con nec tion

In sert the head set plug into the XLR con nec tor. See the head - -
set pinout in the "TR-700 beltpack con trols and con nec tions"
sec tion if this is not a Telex head set. A dy namic or electret
head set mi cro phone is au to mat i cally de tected by the beltpack
and a bias volt age sup plied if needed.
4-9
BATTERY
RELEASE
LATCH