Specifications; Unitidentification; Control Panel - Generac Power Systems 005792-0 Owner's Manual

SPECiFiCATiONS
Engine Type........................ SingleCylinder, 4 -Stroke
EngineSize....................................... 99c0
StarterType ...................................... Recoil
FuelCapacity/Type . .................. 0.8 Ca](3.04L)/Unleaded
Oil Capacity ................................ 0.03 Qt (O.CL)
RuntimeFull/HalfLoad........................ 2.5/4.9 Hours
SparkPlugType ............ DensoU16FSR-UB or NGKCR5H88
SparkPlugGap ..................................... 030"
Dimensions L x Wx H (in) ...................... 22 x 12 x 18
WeightLb/kg .................................. 43.5/19.7
MaximumACOutput.............................. 1600W
SurgeACOutput ................................. 1650W
ACVolts....................................... 120 VAC
RatedACCurrent . ................................. 13.3 A
Frequency....................................... 60 Hz
THD............................................. 3.0%
InsulationClass.................................. ClassF
Outlets .............................. (2) 5-15R, (1) 12 VDC
DCVolts ........................................ 12 VDC
RatedDCCurrent . ................................... 5 A
NOTE:
Power output and runtime are influenced by many factors,
someof which are fuel quality, ambient temperatureand engine
condition. O utput decreases approximately 3.5% for each1 ,O00
feet above sea level and 1% for every 10 degrees above 60°F.
UNITIDENTIFICATION (Figure 2)
1. Carrying Handle: Lift the generatorby this handle only.
2. Spark Plug Cover:Allows access to the enginespark plug.
3. Fuel System Primer: Used to prime the fuel system for
starting.
4. Fuel Cap PressureValve: Allows air to enterthe fuel tank to
equalizepressure.
5. FuelTankCap: Access to fuel tank for filling.
6. Control Panel: location of generator controls and output
receptacles.
7. Air IntakeSlats: Allows for cooling air to enterthe housing.
8. Muffler: Lowers engineexhaust noise.
9. Choke:Cold engine starting aid
10. Left Side Service Cover: Allows access to air filter, fuel filter
and oil fill.
11. VentHoses: Hoses allow venting of the carburetor.
12. FuelShutoff: Controlsfuel supply to the carburetor.
13. Starter Rope: Pull rope for starting engine.
Figure2- Unit Identification
1
\
3
8\
12
11
10
9
CONTROL P ANEL Fi ure3
14. LOW OIL LEVEL LED (yellow): Lights up when oil level is
below safe operatinglevel and the engineshuts down..
15. OVERLOAD LED(red): Lights up if the generatorexperiences
a load greaterthan the ratedoutput, low voltage, overheatsor
the poweredcircuit experiencesa short. The output is stopped
eventhough the enginekeeps running.
16. READY LED (green): Indicates output from the generator
unless there is a low oil or overload condition.
17. 12 VDC Plug: Connectionfor re-charging 12VDCautomotive-
style batterieswhile generatoris in operation.
18. FlexPower
T M
Switch: This switch slows the engine speed
when the load is reducedto savefuel and enginewear.
19. 12 VDC Circuit Breaker: Overloadprotectionfor the 12 VDC
charging system.
20. Ground (Earth) Connection Lug: Grounding point for the
generator; consult state and local electrical codes before use
(floating ground).
21. 120 VAC Receptacles:Two (2) receptacles for connecting
accessories.