Wavelink Avalanche - Cisco 7925G Deployment Manual

Example below:
tftp-server flash: Cp7925g-1.3.3.LOADS
tftp-server flash:Appsh-1.3.3.SBN
tftp-server flash:Guih-1.3.3.SBN
tftp-server flash:Sysh-1.3.3.SBN
tftp-server flash:Tnuxh-1.3.3.SBN
tftp-server flash:Tnuxrh-1.3.3.SBN
tftp-server flash:Wlanh-1.3.3.SBN
!
telephony-service
load 7925 Cp7925g-1.3.3.LOADS
Web Interface
You can upload the firmware to the phone by using the web interface option, Phone Upgrade and browsing to the firmware
TAR file.
Note: If the Cisco Unified Wireless IP Phone 7925G registers to Cisco Unified Communications Manager, web access to the
Cisco Unified Wireless IP Phone 7925G gets set to read-only mode. In this mode, you are not allowed access to upgrade
firmware.
Ultimately the Cisco Unified Wireless IP Phone 7925G will use what is set as the phone load in the Cisco Unified
Communications Manager.

Wavelink Avalanche

The Wavelink Avalanche server IP address can be set either via DHCP option 149 or statically.
To provide the server IP address automatically, configure option 149 on the DHCP server.
ip dhcp pool 10.10.11.0
network 10.10.11.0 255.255.255.0
default-router 10.10.11.1
dns-server 10.10.10.20
domain-name cisco.com
option 150 ip 10.10.10.22
option 149 ip 10.10.11.128
Custom parameters can also be set via the Cisco Unified Wireless IP Phone 7925G web page in order to help group clients for
better management.
Cisco Unified Wireless IP Phone 7925G Deployment Guide 71