Cisco 7925G Deployment Manual page 60

•
If using open authentication plus WEP encryption or shared key authentication, enter the static WEP key
information that matches the access point configuration.
Note: CCKM will be negotiated if enabled on the Access Point when using 802.1x authentication with LEAP, EAP-FAST,
EAP-TLS, PEAP or AKM modes.
WEP with AKM is only applicable with 802.1x authentication (not WPA-PSK).
If using 802.1x authentication via LEAP, EAP-FAST, PEAP or AKM (authenticated key-management) authentication modes,
then you must configure a username and password. AKM mode will use LEAP as the 802.1x method.
•
Select whether to use Dynamic Host Configuration Protocol (DHCP) or configure static IP information.
•
If option 150 or 66 is not configured to provide the TFTP server IP address via the network's DHCP scope, then enter
the TFTP server IP address info.
•
To enable PEAP with server validation, select "Validate Server Certificate" after importing the authentication server
certificate.
•
When using EAP-TLS, select either "Manufacturing Issued" or "User Installed" for the "Client EAP-TLS
Certificate" option after selecting EAP-TLS.
Note: WEP128 is listed as WEP104 on the Cisco Unified Wireless LAN Controllers.
Cisco Unified Wireless IP Phone 7925G Deployment Guide 60