Call Control; Supported Protocols; Supported Access Points - Cisco 7925G Deployment Manual

Call Control

For call control, the Cisco Unified Wireless IP Phone 7925G supports only Skinny Client Control Protocol (SCCP) on the
following applications:
•
Cisco Unified Communications Manager 4.1, 4.2, 4.3, 5.1, 6.0, 6.1, 7.0 and later
•
Cisco Unified Communications Manager Express 4.3 and later (Minimum of 12.4(15)T7)
•
SRST 4.3 and later (Minimum of 12.4(15)T7)
Device Support in Cisco Unified Communications Manager
Cisco Unified Communications Manager requires that you install a device package or service release update in order to enable
Cisco Unified Wireless IP Phone 7925G device support.
Cisco Unified Communications Manager 5.1 or higher requires signed COP files.
Device packages for Cisco Unified Communications Manager are available at
voice.shtml.

Supported Protocols

Supported voice and wireless LAN protocols include these:
•
Real Time Protocol (RTP)
•
G.711u-law, G.711a-law, G.729a, G.729ab, G.722, iLBC
•
Real Time Control Protocol (RTCP)
•
Cisco Discovery Protocol (CDP)
•
Syslog
•
CCX v4
•
Wi-Fi MultiMedia (WMM)
•
Traffic Specification (TSPEC)
•
Traffic Classification (TCLAS)
•
Unscheduled Auto Power Save Delivery (U-APSD) and Power Save Poll (PS-POLL)

Supported Access Points

The Cisco Unified Wireless IP Phone 7925G is supported on both the Cisco autonomous and unified solutions.
•
Cisco Unified Wireless LAN Controller
Minimum = 4.0.217.0 or later
Recommended = 5.2.193.0 or later
•
Cisco IOS Access Points (Autonomous)
Minimum = 12.3(8)JEA2 or later
Recommended = 12.4(10b)JA3 or later (does not apply to 1100, 1140, 1200, 1230)
Cisco Unified Wireless IP Phone 7925G Deployment Guide
http://www.cisco.com/kobayashi/sw-center/sw-
6