Loading Paper Into The Multi Bypass Tray (Tray A) - Ricoh C9100 User Manual

4. Adding Paper and Toner
2. Load paper into the paper tray with print side up.
Do not stack paper over the limit mark.
3. Carefully push the paper tray fully in.
• Various sizes of paper can be loaded in Trays 1, 2, and the wide LCT by adjusting the positions of
side fence and end fence. For details, see "Changing the Paper Size in Trays 1, 2, and the Wide
Large Capacity Tray", Paper Specifications and Adding Paper.
• You can load envelopes in Trays 1, 2, and the wide LCT. When loading envelopes, place them in
the correct orientation. For details, see page 55 "Envelopes".

Loading Paper into the Multi Bypass Tray (Tray A)

Use the multi bypass tray (Tray A) to use transparencies, translucent paper, and paper that cannot be
loaded in the paper trays.
• The maximum number of sheets you can load at the same time depends on paper type. Do not
stack paper over the limit mark. For the maximum number of sheets you can load, see page 44
"Recommended Paper Sizes and Types".
• Check the paper edges are aligned at the left side.
• When loading a low number of sheets, be sure not to squeeze the side fences in too tightly. If the
side fences are squeezed too tightly against the paper, the edges may crease, the paper may
misfeed, or if it weighs between 52.3–63.0 g/m
1. Set the side fences to the paper size, and then square the paper and load it print side up.
Do not stack paper over the limit mark.
36
DER089
2
(14.0–16.9 lb. Bond), it may wrinkle.