Table of Contents
Advertisement
Assembly
Before shipping, the sliding table was installed on
the machine and calibrated to the main table and
blade arbor.
The table and fence components are heavy so
you must get help lifting and holding them during
the installation process.
To assemble the sliding table saw:
1.
Attach the extension table to the main table
with (3) M10-1.5 x 25 cap screws, 10mm
flat washers, and 10mm lock washers (see
Figure 10). Do not fully tighten the cap
screws at this time, because the extension
table still needs to be leveled with the main
table.
Cap Screws
Set Screws
Figure 10. Extension table installed.
2.
Thread (1) M8-1.25 hex nut halfway onto
each of the (4) M8-1.25 x 25 set screws,
then thread the set screws a couple of turns
into the locations shown in Figure 10. These
screws will help you level the table in the next
step.
3.
Adjust the top of the extension table to be
even with the cast iron table and snug the
cap screws down enough to hold the table in
place.
4.
Using a straightedge as a guide (see Figure
11), adjust the set screws to align the top of
extension table with the top of the main table.
When the extension table is fully aligned and
leveled with the main table, tighten the hex
nuts on the set screws against the extension
table to lock them in position.
Model G0700 (Mfd. Since 5/14)
Figure 11. Extension wing mounted and
adjusted evenly with the cast iron table.
5.
Mount the rip fence scale to the main table
and extension table (see Figure 12) with (2)
M6-1 x 16 hex bolts, (1) M6-1 x 25 hex bolt,
and (3) M6-1 hex nuts, 6mm lock washers,
and 6mm flat washers. Do not completely
tighten the fasteners at this time, because
the rip fence scale will need to be calibrated
to the blade during a later step.
Note: The longer hex bolt is used in the cast
iron table. Also, make sure the scale is even
with both table tops before securing it in
place.
Scale
Hex Bolt
Figure 12. Mounting rip fence scale.
Table
Hex Nut
Flat Washer
Lock Washer
-21-
Advertisement
Table of Contents
