Secure SRT323 User And Installation Instructions Manual page 20

Battery Level
Command Class
Wake Up Command
Class (Ver 2)
Thermostat Mode
Command Class
Thermostat Setpoint
Command Class
Association
Command Class
Provides the current battery voltage level Battery
Level Reports on receipt of a battery get
command.
(Battery Level Reports with parameter = 0xFF)
can be sent unsolicited to nodes in Group 3.)
Wake Up Commands are available through the
'Wake Up Capabilities Report'. Default wakeup
settings will be used if the unit is not included
onto a network or has not received a valid wake
up interval.
The only supported mode is type Heat.
The Setpoint type of 'Heating' is supported.
The SRT323 will accept Setpoint SET commands
only if the Setpoint type is 'Heating'. SRT323 will
send a Setpoint REPORT in response to a Setpoint
GET message or unsolicited messages can be sent
to nodes in Group 4 when the set temperature is
changed locally on the SRT323.
The following association groups are supported:
Group 1 - Lifeline. The node associated to this group
will receive messages from all the other groups,
whether or not that group has itself been
associated. Only one node may be associated to
this group.
Continued on next page...
20