12
SERVICE WORK ON THE CHASSIS
12.40
Checking the frame
12.41
Checking the swingarm
12.42
Checking throttle cable routing
–
Check the chain guide for wear.
Info
Wear can be seen on the front of the chain guide.
»
If the light part of the chain guide is worn:
–
Change the chain guide.
401760-01
–
Check that the chain guide is firmly seated.
»
If the chain guide is loose:
–
Tighten the screws on the chain guide.
Guideline
Remaining screws, chassis
Remaining nuts, chassis
K00149-01
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Check the frame for cracking and deformation.
»
If the frame exhibits cracking or deformation due to a mechanical impact:
–
Change the frame.
401340-01
–
Check the swingarm for damage, cracking, and deformation.
»
If the swingarm shows signs of damage, cracking, or deformation:
–
Change the swingarm.
401341-01
Preparatory work
–
Remove the seat. (
–
Remove the fuel tank.
Info
Always replace a frame that has been damaged due to a mechanical
impact. Repair of the frame is not authorized by KTM.
Info
Always change a damaged swingarm. Repair of the swingarm is not
authorized by KTM.
p. 62)
(
p. 66)
M6
10 Nm
(7.4 lbf ft)
M6
10 Nm
(7.4 lbf ft)
p. 51)
73