12
SERVICE WORK ON THE CHASSIS
12.18
Installing the front fender
12.19
Removing the shock absorber
12.20
Installing the shock absorber
–
Remove screws
K00073-10
Main work
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
K00072-10
–
Mount and tighten screws
Guideline
Remaining screws, chassis
K00073-10
Finishing work
–
Refit the headlight mask with the headlight. (
–
Check the headlight setting. (
Preparatory work
–
Raise the motorcycle with the lift stand. (
Main work
–
Remove screw
without blocking the rear wheel. Fix the rear wheel in this position.
–
Remove screw
absorber.
K00074-10
Main work
–
Push splash protector
tighten screw
Guideline
Screw, top shock absorber
–
Mount and tighten screw
K00074-11
. Remove the front fender.
.
p. 96)
and lower the rear wheel with the swingarm as far as possible
, push splash protector
to the side and position the shock absorber. Mount and
.
M12
.
.
M6
10 Nm (7.4 lbf ft)
M6
10 Nm (7.4 lbf ft)
p. 95)
p. 51)
to the side, and remove the shock
80 Nm
Loctite
(59 lbf ft)
61
®
2701™