Checking For Chain Dirt Accumulation; Cleaning The Chain - KTM 500 EXC US Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.35

Checking for chain dirt accumulation

12.36

Cleaning the chain

Warning
Danger of accidents Oil or grease on the tires reduces their grip.
–
Remove oil and grease with a suitable cleaning material.
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
(EXC US)
–
Position the collar bushings, and mount and tighten screws
Guideline
Remaining screws, chassis
K00146-11
(EXC Six Days US)
–
Position collar bushings between the spoiler and radiator shield.
–
Mount and tighten screws
Guideline
Remaining screws, chassis
M01024-11
–
Plug in connector
–
Remove the wash cap set.
–
Thoroughly clean the plug-in connection of the fuel line using compressed air.
Info
Under no circumstances should dirt enter into the fuel line. Dirt in the fuel
line clogs the injection valve.
–
Lubricate the O-ring and connect plug-in connection
S00460-10
Info
Route the cable and fuel line at a safe distance from the exhaust system.
Finishing work
–
Mount the seat. (
–
Check the chain for coarse dirt accumulation.
» If the chain is very dirty:
–
Clean the chain. (
400678-01
M6

with washers.
M6

of the fuel pump.
p. 62)
p. 69)

.
10 Nm
(7.4 lbf ft)
10 Nm
(7.4 lbf ft)

of the fuel line.
69