15
ELECTRICAL SYSTEM
15.1
Removing the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks and open flames away from the battery. Only charge in well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
15.2
Installing the battery
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. (
–
Remove the air filter box cover. (
Main work
–
Disconnect negative cable
–
Pull back positive terminal cover
battery.
–
Detach rubber band
–
Lift the battery up and out.
K00096-10
Main work
–
Insert the battery into the battery compartment with the terminals facing forward.
Battery (YTX5L-BS) (
–
Reconnect rubber band
–
Position the positive cable
Guideline
Screw, battery terminal
Info
Contact disk
with the claws facing down.
–
Slide positive terminal cover
–
Position the negative cable
Guideline
Screw, battery terminal
K00116-10
Info
Contact disk
with the claws facing down.
Finishing work
–
Install the air filter box cover. (
–
Mount the seat. (
p. 62)
p. 62)
from the battery.
and disconnect the positive cable from the
at the bottom.
p. 117)
.
and mount and tighten the screw.
M5
must be mounted between screw
over the positive terminal.
and mount and tighten the screw.
M5
must be mounted between screw
p. 62)
p. 62)
91
2.5 Nm
(1.84 lbf ft)
and cable lug
2.5 Nm
(1.84 lbf ft)
and cable lug