Toshiba Tecra 500CS User Manual page 436

25-diag.fm5 Page 459 Thursday, May 16, 1996 2:23 PM
Diskette Drives
If you selected the diskette drive test, you see a prompt that asks
you to insert a disk into each drive you want to test.
Insert a formatted, write-enabled diskette into each drive(s).
This test may destroy all information on the diskettes. Make
sure there is no information you want to keep on the diskettes
you use.
To skip this test and return to the diagnostics menu, press
+
Ctrl
After you insert the diskette(s) in the drive(s), press
begins and displays this message:
FLOPPY DISK IN PROGRESS 503000
If an error occurs, the test displays the ABORTED message. Write
down the highlighted numbers and return to the main menu by
pressing
If a diskette drive fails the test, check the following:
Does the drive contain a diskette?
Is the diskette properly formatted?
Is the diskette write-enabled?
Is the diskette undamaged?
Repeat the test with another diskette. If the test displays the
ABORTED message again, see your dealer.
If the test completes successfully, and you selected the hard disk
test, the diagnostic test begins checking the hard disk. If you did
not select the hard disk or printer test, the diskette drive test con-
cludes by displaying the TDIAGS screen. To exit TDIAGS, go to
"Exiting the Diagnostic Menus" on page 462.
Part II: Technical Reference
.
Pause
+ .
Ctrl Pause
459
The Diagnostic Test
Test Sequence
. The test
Enter