Error Messages - Yamaha RX-A2010 Owner's Manual

1 2 3 4 5 6 7 8
Automatic speaker setup

Error messages

If any error message is displayed during the measurement, resolve the problem and perform YPAO again.
Error message
E-1: No Front SP Front speakers are not detected.
E-2: No Sur. SP Either of surround speakers is not detected.
E-3: No F.PRNS SP Either of front presence speakers is not detected.
E-4: SBR SBL A surround back speaker is connected to the R side only.
E-5: Noisy The noise is too loud.
Any surround back speaker is connected while no surround
E-6: Check Sur.
speakers are connected.
E-7: No MIC The YPAO microphone has been removed.
E-8: No Signal The YPAO microphone cannot detect test tones.
E-9: User Cancel The measurement has been canceled.
E-10: Internal Error An internal error has occurred.
E-11: No R.PRNS SP Either of rear presence speakers is not detected.
Cause
Follow the on-screen instructions to exit YPAO, turn off this unit, and then check the speaker connections.
When using only one surround back speaker, you need to connect it to the SINGLE jack (L side). Follow the
on-screen instructions to exit YPAO, turn off this unit, and then reconnect the speaker.
Keep the room quiet and follow the on-screen instructions to start the measurement again. If you select
"PROCEED", the measurement starts again on the condition this unit ignores the noisy error even if noises
are detected.
Surround speakers should be connected when using surround back speakers. Follow the on-screen
instructions to exit YPAO, turn off this unit, and then reconnect the speakers.
Connect the YPAO microphone to the YPAO MIC jack firmly and follow the on-screen instructions to start the
measurement again.
Connect the YPAO microphone to the YPAO MIC jack firmly and follow the on-screen instructions to start the
measurement again. If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service
center.
Follow the on-screen instructions to start the measurement again. To cancel the measurement, select "EXIT".
Follow the on-screen instructions to exit YPAO, turn off and on this unit. If this error occurs repeatedly,
contact the nearest authorized Yamaha dealer or service center.
Follow the on-screen instructions to exit YPAO, turn off this unit, and then check the speaker connections.
Remedy
49
En