Editing Device Names - Yamaha RX-A2010 Owner's Manual

SOURCE
SOURCE SOURCE RECEIVER RECEIVER
RECEIVER RECEIVER
AV
1 2 3 4
5 6 7 V-AUX
AUDIO
Input selection keys
1 2 3 4
PHONO MULTI USB NET
DOCK TUNER SIRIUS [ A ]
SCENE
SCENE
1 2 3 4
PROGRAM MUTE VOLUME
External device
TOP MENU POP-UP/MENU
operation keys
ON SCREEN OPTION
Menu operation keys
ENTER
Cursor keys
ENTER ENTER
RETURN DISPLAY
DISPLAY DISPLAY
MODE MODE
External device
MODE
operation keys
HOLD TAG PRG SELECT
LIVE
CLASSICAL ENTERTAIN
CLUB
PRESET
MOVIE STEREO STRAIGHT
TV
PURE
INPUT
DIRECT
TV VOL TV CH
TV operation keys
MUTE
TV
SUR.
ENHANCER PARTY HDMI OUT
DECODE
CATEGOR CATEGORY A A Y
INFO MEMORY FM AM
1 2 3
TUN./ CH TUN./ CH
4 5 6
Numeric keys
7 8 9 SLEEP
10 0 ENT LEVEL
SETUP
ZONE SETUP
ZONE
5
Aim the infrared transmitters of the remote controls
at each other.
Remote control of external device
5 to 10 cm apart
6
Perform the following steps (a and b) within
10 seconds.
a On this unit, press one of the following keys to which you want to
assign a function.
For playback device: SOURCE
DISPLAY, MODE, external device operation keys, numeric keys
For TV: TV operation keys
b On the external device, press the key from which the operation
is learned until "OK" appears in the display window.
If "NG" appears, learning failed. Repeat from step 4.
7
Repeat steps 3 to 6 until all desired operations are
learned.
8
To exit from the setup menu, press SETUP.
• This remote control can learn approximately 200 functions (may be
decreased depending on the signals). If "FULL" appears in the display
window, clear unnecessary assignments to free some memory space for the
new functions.
Note
• If you press RECEIVER
receiver to the menu operation keys, external device operation keys or
numeric keys. However, it makes these keys to control this unit impossible. If
you need to restore the remote control code for this unit, perform the following
steps.
a Press SETUP.
b Use the cursor keys ( / ) to select "CLEAR" and press ENTER.
c Use the cursor keys ( / ) to select "LEARN" and press ENTER.
d Press RECEIVER
e Hold down ENTER until "OK" appears on the window display.
f To exit from the setup menu, press SETUP.

Editing device names

You can edit the device names or scene names displayed on the
remote control's display window.
1
, menu operations keys,
2
3
in step 3, you can assign functions of an external
.
Press SETUP.
Perform each of the following steps within 30 seconds.
Otherwise, the setting will be canceled. In this case, repeat
from step 1.
Use the cursor keys ( / ) to select "RENAME" and
press ENTER.
RENAME
Press one of the following keys to select a device or
a scene.
For playback device: press the input selection key
(corresponding to the input jacks where the device is
connected).
For TV: press TV .
For AV receiver (this unit): press RECEIVER
For scene: press one of the SCENE keys.
• To edit scene names of each zone, press one of the SCENE keys and press
ZONE to select a zone.
.
131
En