Updating The Firmware Of This Unit - Yamaha RX-A2010 Owner's Manual

SOURCE SOURCE RECEIVER RECEIVER
AV AV
1 1 2 2 3 3 4 4
5 5 6 6 7 7 V-AUX V-AUX
AUDIO AUDIO
1 1 2 2 3 3 4 4
PHONO PHONO MULTI MULTI USB USB NET NET
DOCK DOCK TUNER TUNER SIRIUS SIRIUS [ A ] [ A ]
SCENE
1 2 3 4
PROGRAM MUTE VOLUME
TOP MENU POP-UP/MENU
ON SCREEN OPTION
Cursor keys
ENTER
ENTER ENTER
RETURN DISPLAY
MODE
HOLD TAG PRG SELECT
LIVE
CLASSICAL ENTERTAIN
CLUB
PRESET
MOVIE STEREO STRAIGHT
TV
PURE
INPUT
DIRECT
TV VOL TV CH
MUTE

Updating the firmware of this unit

If this unit is connected to the Internet, the corresponding message
will be displayed on the TV when a newer firmware is available. In
this case, follow the procedure below to update the firmware of this
unit.
Note
• Do not operate this unit or disconnect the power cable or network cable during
firmware update. Firmware update takes about 15 minutes.
• You can also update the firmware using the USB memory device from the
"ADVANCED SETUP" menu (p.127).
If the following message is displayed after ON SCREEN is pressed,
firmware update is available.
1
Read the on-screen description.
2
To start the firmware update, use the cursor keys to
select "START" and press ENTER.
The on-screen display turns off.
3
If "UPDATE SUCCESS PLEASE POWER OFF!"
appears on the front display, press MAIN ZONE
on the front panel.
The firmware update is complete.
• If you want to update the firmware later, select "CLOSE" in step 2. In this
case, "!" (exclamation mark) appears at the upper right of the "Information"
and "System" icons, and the corresponding message will be displayed in the
"System" screen (p.124). You can update the firmware of this unit by
pressing ENTER in the "System" screen.
Information
icon
Message
System icon
137
En