Sound - Yamaha RX-A2010 Owner's Manual

Sound

Configures the audio output settings.
■
Lipsync
Adjusts the delay between video and audio output.
❑ Auto
Adjusts the delay between video and audio output automatically when a TV that
supports an automatic lipsync function is connected to this unit via HDMI. If necessary,
you can fine-adjust the audio output timing. "Offset" shows the difference between
automatic adjustment and fine adjustment.
Setting range
0ms ~ 500ms (1ms steps)
Default
0ms
❑ Manual
Adjusts the delay between video and audio output manually.
Setting range
0ms ~ 500ms (1ms steps)
Default
0ms
■
Dynamic Range
Selects the dynamic range adjustment method for bitstream audio (Dolby Digital and
DTS signals) playback.
Settings
Maximum (default) Produces audio without adjusting the dynamic range.
Standard Optimizes the dynamic range for regular home use.
Sets the dynamic range to make clear sound even at night or at low
volumes.
Minimum/Auto
When playing back Dolby TrueHD signals, the dynamic range is
automatically adjusted based on the input signal information.
■
Max Volume
Sets the maximum volume so that sound is not too loud.
Setting range
-30.0dB ~ +15.0dB (5.0dB steps), +16.5dB
Default
+16.5dB
■
Initial Volume
Sets the initial volume for when this receiver is turned on.
Settings
Off (default) Sets at the level when this unit last entered standby mode.
Sets at Mute, or -80.0dB ~ +16.5dB (0.5dB steps). (This setting works
On
only when "Max Volume" is set higher.)
■
Pure Direct Mode
Selects whether to output video signals during the Pure Direct mode (p.58).
Settings
Automatically outputs video signals when any videos are input from the
selected input source or an input source that can be operated with the
Auto (default)
on-screen display is selected. When no video signals are input, the wall
paper is displayed.
Video Off Does not output video signals including the wall paper.
113
En