Yamaha RX-A2010 Owner's Manual page 20

1 2 3 4 5 6 7 8
Speaker connections
❑ Connecting speaker cables
Speaker cables have two wires. One is for connecting the negative (-) terminal of the unit
and the speaker, and the other is for the positive (+) terminal. If the wires are colored to
prevent confusion, connect the black wire to the negative and the other wire to the positive.
a Remove approximately 10 mm (3/8") of insulation from the ends of the speaker cable, and
twist the bare wires of the cable together firmly.
b Loosen the speaker terminal.
c Insert the bare wires of the cable into the gap on the side (upper right or bottom left) of the
terminal.
d Tighten the terminal.
c c
F R
+ (red)
O N
T
b b
a a
d d
– (black)
Using a banana plug
a Tighten the speaker terminal.
b Insert a banana plug into the end of the terminal.
a a
F R
O N
T
Banana plug
b b
❑ Connecting the subwoofer
Use an audio pin cable to connect the subwoofer.
Audio pin cable
20
En