Granite Extension Wing Assembly - Steel City 35920 User Manual

GRANITE EXTENSION WING ASSEMBLY

CAUTION: The granite extension wing is heavy; two
people are required for assemble.
1. Install 2 T supporting bars (A) into the T-slot under
main table. SEE FIG 7.
installed all the way into the slot, under the main table.
2. Thread the (3) 5/16-18x2" hex soc. Set screws (B) into
the edge of the granite table.
Fig. 7
3. Find some help for lifting the extension table. Line up
both slots with the support bar until the extension table
reaches the main table. Make sure the (3)5/16-18x2
screws protrude into the extension wing to allow the
fastening of the hex nut as shown in
Fig. 8
4. Install the both M8 Flat & lock washers and secure
the 5/16-18 hex nut. Do not tighten until the wing is
Level.
Make sure the support bar is
FIG. 9 .
Fig.9
5. Install 4 of M8x20 Hex Soc Set Screws on both of
the T-supporting bars.
Fig. 10
6. Use a straight edge across to the main table and
extension wing, checking the flatness of both main
and extension table.
7. Use a 4 mm Allen wrench to adjust the setting screw
to raise or lower the extension wing to the table.
"
Fig. 11
8. Using a 13 mm wrench secure the 5/16-18 hex nut
in FIG. 9 .
9. Check the flatness of the table and extension wing
with a straight edge. Make sure both tables are the
same level. If not, refer to step 7 and 8 until completely
Adjusted.
19
SEE FIG 10 .
SEE FIG 11.