Assembly; Section 10 Assembly - Steel City 35635 User Manual

WARNING
!
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
INSTALLATION AND LEVELING
Final location for the saw must be level, dry, well light-
ed, and have enough room to allow movement around
the saw with long pieces of wood stock.
Level the saw front to back and side to side, using a
carpenter's level placed on the table. Use shims under
the corners, if necessary, but make sure the saw is
stable before being placed into service.
EXTENSION WING ASSEMBLY
1. Attach extension wing to the table with three hex
head bolts, three lock washers, and three flat wash-
ers. Snug but do not tighten.
2. Slide extension wings toward the front edge of the
saw table until two edges are flush. Make certain
that the beveled edge of the wing faces towards the
front of the saw.
Fig. 2
A
3. Using a straight edge (A), align the extension wings
to the saw table and tighten the hex head bolts.
SEE FIG. 2.
4. Repeat Steps 1-3 for the other wing.

ASSEMBLY

HANDWHEEL ASSEMBLY
Fig. 3
1. Line up the key on the shaft with the keyway in the
handwheel (A), and slide the handwheel onto the
shaft. SEE FIG. 3.
2. Tighten the set screw on the handwheel hub
securely to hold in place.
3. Install center lock knob (B) by inserting into center
hole in the shaft and threading in a clockwise
direction.
19
A
B