The Suction Motor Does Not Function; The Brush Motor Does Not Work; It Is Impossible To Raise Or Lower The Base Or Squeegee - Victor MR 60B Use And Maintenance Manual

THE SUCTION MOTOR DOES NOT FUNCTION

1. Check whether the recovery tank is full and, if necessary, empty it.
2. Check the float switch on the suction cap (see also "CLEANING THE RECOVERY
TANK" in the chapter "DAILY MAINTENANCE").

THE BRUSH MOTOR DOES NOT WORK

ATTENTION To avoid damaging the floor, the motor only starts up when the machine is
moved forwards.
1. Check that the base is lowered during the forward movement with the right lever (1)
turned clockwise.
2. The operator must be properly seated in the driving position.
3. Check no thermal protection device has intervened.
4. Check the correct connection of the motor to the terminal under the footboards.

IT IS IMPOSSIBLE TO RAISE OR LOWER THE BASE OR SQUEEGEE

The machine is fitted with electrical protection devices that control the base and
squeegee ascent/descent motor reducers. In the event of overloading, the fuses
interrupt the power supply. After checking and removing the reason for the problem, to
reset them just switch the machine off then on again. If the problem persists, contact
the FIMAP technical assistance centre.
THE MACHINE DOES NOT START
1. Check that connector (1) is connected to the batteries.
2. Check the key switch is ON/I.
3. Check that batteries (2) are charged.
TROUBLESHOOTING
25