Table of Contents
Advertisement
REPLACING THE FRONT SQUEEGEE RUBBER
Suction will be poor and the machine will not dry perfectly if the front squeegee rubber is
worn. Proceed as follows to replace:
1. Remove the squeegee from the support arm by unscrewing the handwheel.
2. Turn the wing nuts (1) in the horizontal position.
3. Remove the front rubber-pressing blades (2).
4. Remove the rubber (3) and replace it.
5. Proceed in reverse to replace the rubber.
REPLACING THE REAR SQUEEGEE RUBBER
If the squeegee rear rubber is worn and does not dry well, it is possible to change the
drying edge using one of the 4 edges of the rubber.
This operation can be done both with a squeegee fitted or removed as follows:
1. Turn the wing nuts (1) in the horizontal position.
2. Remove the rear rubber-pressing blades (2).
3. Remove the rubber (3) and replace it.
4. Proceed in reverse to replace the rubber.
5. Adjust the height of the squeegee depending on the rubber (see "ADJUSTING THE
HEIGHT OF THE SQUEEGEE SUPPORT").
REPLACING THE BASE SPLASH GUARD
Periodically check the condition of the base casings that serve as protection to the
rotation of the brushes. To replace proceed as follows:
1. With the base lowered, remove the fixing screws of the casing to the base.
2. Remove the casing.
3. Fit the new casing with the screws previously removed.
WARNING: Before performing any maintenance, remove the keys
from the panel and disconnect the battery connector of the machine.
WARNING: The housing can prevent damage to persons or
property. Always check for wear.
EXTRAORDINARY MAINTENANCE
23
Advertisement
Table of Contents
