Daily Maintenance; Cleaning The Recovery Tank; Cleaning The Squeegee - Victor MR 60B Use And Maintenance Manual

CLEANING THE RECOVERY TANK

1. Disconnect the tube (1) from its seat, unscrew the drainage cap and empty the
recovery tank.
WARNING: This operation must be carried out using gloves to
protect against contact with dangerous solutions.
WARNING: Before performing any maintenance, remove the keys
from the panel and disconnect the battery connector of the
machine.
2. Raise the cap (2) until the hook is secured to the prop (3) of the recovery tank.
3. Make sure to clean the filter inside the lid (4). To access the filter, remove the
protection of the intake filter turning it clockwise, remove it and clean it under
running water.
4. Clean and rinse the recovery tank and the suction pipe (connecting pipe between the
squeegee and the tank).
5. Reposition the cap on the drainage tube and lower the suction cap. To lock the prop
(3) just slightly raise the cap, release the prop (3) and lower the cap up to
close it.

CLEANING THE SQUEEGEE

The careful cleaning of the whole suction group ensures better drying and cleaning of the
floor as well as greater duration of the suction motor. Proceed as follows for cleaning:
1. Slide the suction tube (1) from the squeegee sleeve.
2. Remove the squeegee (2) from the support arm by unscrewing the handwheel (3).
3. Check the wear of the rubbers. If the edge of the rubber is ruined, the rear rubber can
be turned on all four corners. If the rubbers are completely worn proceed with
the replacement. To remove the rubber, turn the wing nuts (4) in a horizontal position,
remove the rubber-pressing blade (5) and then remove the rubber to turn it
or replace it.
4. Proceed in reverse to replace the rubber.
5. After cleaning, replace the squeegee (2) on the initial support, firstly inserting the left
pin of the squeegee in the left slot of the arm, then the right pin in the right slot,
being careful to keep the spring and washer on the plate of the arm. This can be
simplified by first loosening the handwheel (3) on the pin. Then retighten the
handwheel (3) to block the squeegee in place.
6. Finally insert the squeegee tube in the special sleeve.
WARNING: Before performing any maintenance, remove the keys
from the panel and disconnect the battery connector of the
machine.

DAILY MAINTENANCE

20