At The End Of The Work - Victor MR 60B Use And Maintenance Manual

At the end of the work, and before carrying out any type of maintenance, perform the
following operations:
1. Close the tap (1).
2. Lift the base by turning the right lever (2) counterclockwise, then lift the squeegee
turning the left lever (3) clockwise. The suction motor turns off after a few seconds.
3. Take the machine to the location designated for draining the water.
4. Turn the machine off by turning the key one quarter counterclockwise and remove it
from the panel.
5. Engage the parking brake.
WARNING: Before performing any maintenance, remove the keys
from the panel and disconnect the battery connector of the machine.
6. Disconnect the tube (4) from its seat, unscrew the drainage cap and empty the
recovery tank.
WARNING: This operation must be carried out using gloves to
protect against contact with dangerous solutions.
7. Slide the suction tube (5) from the squeegee sleeve.
8. Remove the squeegee (6) from the support arm by unscrewing the handwheel (7).
9. Clean well both the squeegee and the rubbers with a jet of water.
10. After cleaning the squeegee and rubbers, replace the squeegee on the initial
support, firstly inserting the left pin of the squeegee in the left slot of the arm, then
the right pin in the right slot, being careful to keep the spring and washer on the plate
of the arm. This can be simplified by first loosening the handwheel on the pin.
Then retighten the handwheel to block the squeegee in place.
11. Finally insert the squeegee tube in the special sleeve.

AT THE END OF THE WORK

19