Table of Contents
Advertisement
6. BATTERY CHARGER CONNECTION (only versions without CB)
The battery connector is found in the battery compartment by opening the recovery tank.
The connector (1), connected to the batteries, must be detached from machine
connector (2) and hooked up to the battery charger connector for charging. The
coupling connector is delivered in a bag inside the battery compartment, and must be
connected to the cables of the battery charger as indicated in the instructions (see the
battery charger manual).
ATTENTION: This process must be carried out by qualified
personnel. The incorrect or imperfect connection of the cables to
the connector can seriously harm people and damage objects.
7. RECHARGING THE BATTERIES
In order not to cause permanent damage to the batteries it is essential to avoid their
complete discharge: arrange the recharge within a few minutes of the switching on of
the flashing "discharged batteries" signal.
NOTE: Never leave the batteries completely flat, even if the machine is not being used.
Check the electrolyte level and top up with distilled water if necessary (batteries with
electrolyte fluid) every 10 charges.
WARNING: During recharging, keep the tank lifted and blocked with
the appropriate prop. Check the battery charger is suitable for the
batteries installed, in terms of both capacity and type
(lead/acid or GEL and equivalents). Never recharge GEL batteries
with an unsuitable battery charger. Follow the instructions given by
the battery/battery charger manufacturer with the utmost attention.
Danger of fire: Keep naked flames at a safe distance.
Danger of gas exhalation and leakage of corrosive liquids.
MACHINE PREPARATION
11
Advertisement
Table of Contents
