Table of Contents
Advertisement
16.DETERGENT SOLUTION
Fill with clean water at a temperature not exceeding 50°C. The solution tank can be filled
either through the opening (1) with a screw cap, or the rubber cap (2), which also supports
the water hose. If the supply is made via the rubber cap, unscrew the cap to allow the air to
vent correctly. Add the liquid detergent (3) into the solution tank, in the concentration and
manner specified by the manufacturer. The formation of excess foam could damage the
suction motor, so use only the minimum amount of detergent necessary.
Make sure the recovery tank is empty, otherwise empty it completely.
WARNING: Always use detergents whose manufacturer's label
indicates their suitability for scrubbing machines. Do not use acid
or alkaline products or solvents without this indication.
In addition, you are advised to always use low foam detergents.
Do not use pure acids or detergents with a stronger gradation than
that indicated on the label supplied.
ATTENTION: Put on protective gloves before handling
acid/alkaline detergents or solutions, to avoid the risk of burning
your hands.
17. EMPTY SOLUTION TANK DEVICE
To check the quantity of water in the solution tank there is a special level indicator tube
(5) next to the driver's seat.
MACHINE PREPARATION
15
Advertisement
Table of Contents
