Table of Contents
Advertisement
10. BATTERY CHARGE LEVEL INDICATOR
The battery indicator uses LEDs and has 8 positions (7 yellow - charged batteries, and
1 red - run down batteries).
WARNING: A few seconds after the red indicator light comes on,
the brush motor switches off automatically. With the remaining
charge it is possible to complete the drying process before
recharging
11. ASSEMBLING THE SQUEEGEE
For packaging reasons, the squeegee is supplied disassembled from the machine, and
must be assembled as shown in the figure.
Raise the squeegee connection by means of the left lever (1) turning it clockwise into the
vertical position.
Firstly insert the left pin (2) of the squeegee into the left slot on the arm and then the right
pin (3) into the right slot, being careful to keep the spring and the washer above
the arm's flat bar. This can be simplified by first loosening the handwheel on the pin.
Then retighten the handwheel to block the squeegee in place.
Insert the squeegee tube in the appropriate sleeve (4).
12. SQUEEGEE INCLINATION
During working operation, the rear rubber is slightly tilted backwards (by about 5mm) in
a uniform way for its whole length.
If it is necessary to increase the bend of the rubber in the central part, you must tilt the
squeegee backwards, rotating the adjuster screw (1) clockwise.
13. ADJUSTING THE SQUEEGEE SUPPORT HEIGHT
The height of the squeegee must be adjusted on the basis of the state of wear and tear
of the rubber.
Carry out the following operations for adjustment:
unscrew the locking nut
raise or lower the wheel (1) by sliding it on the slot of the support
block it by tightening the locking nut once the required height is reached.
Note: To facilitate the operation, completely lower the squeegee and put a spacer of a
few millimetres (2 to 4 mm depending on the type of rubber) under the wheel.
MACHINE PREPARATION
13
Advertisement
Table of Contents
