Table of Contents
Advertisement
WARNING: If problems arise during operations, turn off the key, engage the parking
brake by pushing the lever (9) to the left until the machine brakes and release the
emergency lever placed below the operator. These commands block all moving
machine parts. Having resolved the problem, to start working again, reconnect the
connector, turn on the key and release the parking brake lever.
The machine will not start if the operator is not properly seated.
A flashing red warning light appears on the display when the battery charge level is
getting too low. The brush motor automatically turns off; batteries must be recharged
as soon as possible.
A residual charge remains so you can complete the drying operation and move the
machine to the recharging point.
OVERFLOW DEVICE
The machine is not equipped with an overfill device, because the capacity of the recovery
tank is greater than the capacity of the solution tank. In extreme cases, there
is a mechanical device (float) on the lid that closes the passage of air to the engine intake
protecting it when the recovery tank is full. In this case, turn the working knob to
transfer (movement of the machine without working), and the engine turns off after about
15-25 seconds. Then proceed with emptying the recovery tank through a special
drainage pipe (10).
It is good practice when restoring the level of the solution tank, to empty the recovery
tank through the special drainage pipe (10).
TRACTION
This machine is equipped with electronic traction control.
To move the machine, after having turned the key, push the drive pedal (11) adjusting
the speed by pressing the pedal more or less. The machine will then start moving.
To make a reversing manoeuvre, press both pedals (11 and 12) the machine will then
start moving backwards. During reverse motion, the machine emits an acoustic signal.
BRAKES
The machine has an electronic braking system. To brake, in normal conditions, just
remove your foot from the accelerator pedal. If the service brake does not operate
properly or in case of need (parking, danger, etc.) actuate the mechanical brake pedal
(13) by pushing it down and locking it by pulling the lever (14) to the left until the pedal
(13) is locked.
WORK
17
Advertisement
Table of Contents
